Residential Drywall Installation in Crystal River, FL

Residential drywall installation in Crystal River costs $2.00 to $3.50 per square foot, hung and finished, in 2026 — the same rate as our main installation page, scoped here to houses: new construction, room additions, and garage and lanai conversions. The written quote splits board, hang, finish, and texture into lines after a free site look.

Talk to a Drywall Specialist: (352) 670-3571

Check your ZIP

Type your ZIP code. We will tell you if we serve your street.

Two workers hanging drywall panels in Crystal River, FL

A job like this one

A room addition went from framed studs to paint-ready walls in four days. Ceilings went up first, walls pushed tight under them, and the tie-in seam where the addition met the original house was floated wide so it reads as one wall.

Sample price
$2.00 to $3.50 per sq ft, hung and finished
Sample turnaround
Three to five days with dry time for most homes.
Residential garage with finished drywall in Crystal River, FL
Residential garage with finished drywall in Crystal River, FL

A home install is won before the first sheet: framing checked flat, rough-in and insulation confirmed complete, and blocking in for TVs, cabinets, and grab bars while the walls are still open. Retrofitting any of that later means cutting new board back open.

What the job covers

What it does not cover

Homes around Crystal River

Housing stock in Citrus County mixes new subdivisions with older block homes whose perimeter walls are furred concrete block — a standard local build we board every week. Waterfront and canal homes near Kings Bay and the lower Crystal River often have elevated floors and enclosed lower areas that need board too. For whole-home pricing context, see the drywall cost guide.

Questions on residential drywall installation

Need help in Crystal River?

Call (352) 670-3571 or send the form. We will tell you plainly what the job needs and what it tends to cost before work starts.

Get a free estimate

Frequently Asked Questions

How is the price set?

By the square foot of wall and ceiling, at $2.00 to $3.50 hung and finished. Ceiling height, board type, and finish level move the rate inside that range.

Do you hang and finish, or just hang?

Both, as one scope. The same crew that hangs the board tapes and finishes it, so nothing is lost between trades.

What has to be done before you start?

Framing finished, and electrical, plumbing, HVAC, and insulation rough-in complete — plus any rough-in inspection your project requires signed off.

Can I stay in the house during an install?

For a room or an addition, usually yes, with containment up. A whole-house hang is a building site; we will tell you plainly which side of that line your job falls on.

Is the site look free?

Yes. The look and the written quote cost nothing.

What Does My Drywall Project Cost?

Drywall is priced by the square foot of wall and ceiling surface — not by the size of your floor. That one fact explains most of the gap between quotes. Here are the ranges we see on real jobs around Crystal River, and a calculator built on the same numbers.

Drywall Repair & Patch

Most single repairs land between $250 and $800. Pros price patches by the square foot of damaged area — roughly $55–$75 a foot around Crystal River — but every repair carries a minimum job charge, because a patch takes the same setup and the same repeat trips for drying coats whether it's the size of a dinner plate or a door. Grouping several spots into one visit is the cheapest way to fix them: they share one minimum. Some repairs are priced flat by the job instead of the square foot: a cut-out ceiling section replaced and texture-matched (an 8×10 section ran $720 flat), long seam cracks (46 linear feet of re-taped seams across three rooms ran $540 flat), and popcorn removal finished smooth (230 sq ft ran $575 flat).

New Drywall Installation

For bare studs finished paint-ready (a standard Level 4 finish), plan on $1.60–$3.00 per sq ft of wall and ceiling surface, materials and labor included. A typical 12×12 bedroom with 8-foot ceilings — that's 528 sq ft of surface — runs about $890–$1,660 around Crystal River.

Room Remodel & Replacement

Tearing out old drywall and hauling it off adds $0.60–$1.25 per sq ft on top of new installation — a combined $2.20–$4.25 per sq ft. That same 12×12 bedroom, gutted and re-drywalled, runs about $1,210–$2,310. Opening walls can uncover surprises — water damage, old wiring — and those get priced once they're visible, never guessed at in advance.

Garage Drywall

Garages run $1.55–$3.30 per sq ft depending on finish. Code requires 5/8-inch fire-rated (Type X) board on the wall shared with the house, and on the ceiling when there's living space above it — that's the fire separation, not an upsell. Most two-car garages land between $1,900 and $4,100 finished.

Texture, Skim & Paint

On walls that are already up: skim coating runs $0.95–$1.30 per sq ft, orange-peel or knockdown texture $0.80–$1.85, and primer plus two coats of paint $1.05–$2.85. A typical room's walls — about 415 sq ft of surface — usually land between $750 and $1,980 for texture and paint together.

What Moves the Price

  • Finish level. A full Level 5 skim coat (for gloss paint or bright, raking light) costs more than standard paint-ready Level 4.
  • Ceilings. Overhead work runs roughly 20–25% more than the same area on a wall — lifts, heavier board, two sets of hands.
  • Ceiling height. Taller walls mean longer sheets, scaffolding, and slower work.
  • Texture matching. Blending a patch into existing orange peel or knockdown is hand work, and it's priced like it.
  • Tear-out. Removing old drywall and disposing of it is its own line on the quote.
  • Job size. Small jobs carry a minimum charge; on big jobs the setup spreads over more feet, so the per-foot price drops.

These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.

A note on materials. These ranges are figured with standard drywall board and the finish level you pick above. Board isn't all the same price, though: moisture- and mold-resistant board — the green or purple board for bathrooms and basements — costs more a sheet than standard board, and on a big job that can push you toward the top of your range, or a little past it. Tell us where the work is and we'll confirm the exact board and the price at the in-person estimate, before any work starts.

Estimate Your Project

1 · Pick your project
Your estimated range

Free — no obligation. Your calculator numbers ride along with the request.

📞 (352) 670-3571