Garage Drywall Installation in Crystal River, FL
Garage drywall installation in Crystal River costs $1.75 to $3.25 per square foot in 2026 — below an equivalent interior room, because the finish level is usually lower, not because the work is easier. Plenty of garages here were handed over with bare studs, exposed insulation, and trusses overhead. A garage is its own category of job, and treating it like a bedroom is how it gets quoted wrong.
Talk to a Drywall Specialist: (352) 670-3571
Check your ZIP
Type your ZIP code. We will tell you if we serve your street.

A job like this one
A two-car garage went from bare studs to a finished shell in three days: ceiling first, fire-rated board on the house wall, blocking set for the shelving and bike hooks the owner actually planned, and a clean tape-and-coat finish that did not pretend to be a living room.
- Sample price
- $1.75 to $3.25 per sq ft, hung and finished
- Sample turnaround
- A standard two-car garage runs two to four days across visits.

Two decisions set a garage job. First, the separation: where a garage adjoins living space, a fire-rated separation is a standard code requirement, typically built with specified board on the house wall and ceiling below any rooms above. Second, conditioning: an unconditioned garage lives in Gulf humidity all year, which argues for moisture-tolerant board low on the walls and around water heaters and laundry gear.
What the job covers
- Full wall and ceiling boarding, from bare shell to finished space
- Fire separation assemblies on the house wall and, where required, the ceiling
- Partial-finish completion, bringing halfway garages to one consistent standard
- Blocking for shelving, overhead racks, cabinets, and workbenches, set at the positions you actually want
What it does not cover
- Garage door and opener work. We board around them; the door trades are separate.
- Epoxy or floor coatings. The slab is left swept and clean; floor finishes are another trade.
- Conditioning the space. If the garage will be air-conditioned later, tell us — it changes the board call, and it is cheap to get right now.
Garages live harder here
An unconditioned garage in Citrus County sits in ambient humidity year-round, takes storm-season damp through the door seals, and hosts the water heater and laundry for half the homes in the county. Lower wall sections pay for all of it first. The rated house-wall work connects to the fire-rated page, and whole-home installs are on the residential installation page.
Questions on garage drywall installation
Need help in Crystal River?
Call (352) 670-3571 or send the form. We will tell you plainly what the job needs and what it tends to cost before work starts.
Get a free estimate
Related Services
Drywall Installation · Commercial Drywall Installation · Drywall Partition Installation · Fire-Rated Drywall Installation · Metal Stud Framing · Moisture and Mold-Resistant Drywall · Residential Drywall Installation · Soundproof and Acoustic Drywall Installation · Suspended Ceiling Installation
Frequently Asked Questions
How is the price set?
Per square foot at $1.75 to $3.25. The finish level is the main lever: a clean utility finish sits low; a Level 4 finish for a future conversion sits high.
Does my garage need fire-rated board?
Where it adjoins the house, a fire separation is a standard requirement, and it is typically achieved with drywall of a specified type and thickness. We confirm what your plans and code require at the look.
Is moisture board worth it in a garage?
In this climate, on lower walls and around water heaters and laundry appliances, yes — those sections live damp. The rest of the garage is fine in standard board.
Can you add backing for shelves and racks?
Yes, and now is the time — blocking goes in before the board, at the exact positions for your shelving, racks, and benches.
Is the site look free?
Yes. The look and the written quote cost nothing.
What Does My Drywall Project Cost?
Drywall is priced by the square foot of wall and ceiling surface — not by the size of your floor. That one fact explains most of the gap between quotes. Here are the ranges we see on real jobs around Crystal River, and a calculator built on the same numbers.
Drywall Repair & Patch
Most single repairs land between $250 and $800. Pros price patches by the square foot of damaged area — roughly $55–$75 a foot around Crystal River — but every repair carries a minimum job charge, because a patch takes the same setup and the same repeat trips for drying coats whether it's the size of a dinner plate or a door. Grouping several spots into one visit is the cheapest way to fix them: they share one minimum. Some repairs are priced flat by the job instead of the square foot: a cut-out ceiling section replaced and texture-matched (an 8×10 section ran $720 flat), long seam cracks (46 linear feet of re-taped seams across three rooms ran $540 flat), and popcorn removal finished smooth (230 sq ft ran $575 flat).
New Drywall Installation
For bare studs finished paint-ready (a standard Level 4 finish), plan on $1.60–$3.00 per sq ft of wall and ceiling surface, materials and labor included. A typical 12×12 bedroom with 8-foot ceilings — that's 528 sq ft of surface — runs about $890–$1,660 around Crystal River.
Room Remodel & Replacement
Tearing out old drywall and hauling it off adds $0.60–$1.25 per sq ft on top of new installation — a combined $2.20–$4.25 per sq ft. That same 12×12 bedroom, gutted and re-drywalled, runs about $1,210–$2,310. Opening walls can uncover surprises — water damage, old wiring — and those get priced once they're visible, never guessed at in advance.
Garage Drywall
Garages run $1.55–$3.30 per sq ft depending on finish. Code requires 5/8-inch fire-rated (Type X) board on the wall shared with the house, and on the ceiling when there's living space above it — that's the fire separation, not an upsell. Most two-car garages land between $1,900 and $4,100 finished.
Texture, Skim & Paint
On walls that are already up: skim coating runs $0.95–$1.30 per sq ft, orange-peel or knockdown texture $0.80–$1.85, and primer plus two coats of paint $1.05–$2.85. A typical room's walls — about 415 sq ft of surface — usually land between $750 and $1,980 for texture and paint together.
What Moves the Price
- Finish level. A full Level 5 skim coat (for gloss paint or bright, raking light) costs more than standard paint-ready Level 4.
- Ceilings. Overhead work runs roughly 20–25% more than the same area on a wall — lifts, heavier board, two sets of hands.
- Ceiling height. Taller walls mean longer sheets, scaffolding, and slower work.
- Texture matching. Blending a patch into existing orange peel or knockdown is hand work, and it's priced like it.
- Tear-out. Removing old drywall and disposing of it is its own line on the quote.
- Job size. Small jobs carry a minimum charge; on big jobs the setup spreads over more feet, so the per-foot price drops.
These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.
A note on materials. These ranges are figured with standard drywall board and the finish level you pick above. Board isn't all the same price, though: moisture- and mold-resistant board — the green or purple board for bathrooms and basements — costs more a sheet than standard board, and on a big job that can push you toward the top of your range, or a little past it. Tell us where the work is and we'll confirm the exact board and the price at the in-person estimate, before any work starts.
Estimate Your Project
Measure the damaged section itself — length × width. A full 4×8 sheet section is 32 sq ft.
Spots done in one visit share a single minimum charge.
Price includes tearing out the old drywall and hauling it off.
Includes 5/8″ Type X fire-rated board on the wall shared with the house — and on the ceiling when there is living space above it — as code requires.
Free — no obligation. Your calculator numbers ride along with the request.
Send Your Project to Crystal River Drywall Specialists
Your estimate is attached automatically. Add your info and — if you can — a few photos of the project. Photos help us price the job before we ever set foot in the house. Prefer to talk? Call (352) 670-3571.