Drywall Patching in Crystal River, FL

Drywall patching in Crystal River runs $250 to $750 per visit in 2026, priced on the visit and the list — not per hole. Patching is the small end of drywall work and the part most people meet first, and the method depends entirely on the size of the opening: that is where most DIY attempts go wrong.

Talk to a Drywall Specialist: (352) 670-3571

Check your ZIP

Type your ZIP code. We will tell you if we serve your street.

Hands fastening a drywall patch into a wall opening in Crystal River, FL

A job like this one

A rental turnover list held eleven patches: anchor holes, a doorknob dent, a torn-out towel rail, and two corner knocks. Priced as one list and done across two visits, the unit was prime-ready for the next tenant.

Sample price
$250 to $750 per visit, list priced as a group
Sample turnaround
One to two visits; coats need dry time between them.
Hands securing a square drywall patch over a wall cutout in Crystal River, FL
Hands fastening a drywall patch into a wall opening in Crystal River, FL

A nail hole, a doorknob hole, and a plumbing access cut are three different jobs wearing the same name. Anything bigger than a small hole gets backing or a fitted board piece; compound alone over a void fails at the first bump. The practical advice we give everyone: save the small stuff up and let one visit clear the list.

What the job covers

What it does not cover

Patch lists around Citrus County

What we patch follows how a property is used: doorknob holes in family homes, anchor damage in the county's many rental turnovers, fixture tear-outs in remodels, and access cuts wherever a plumber has been. Construction type matters too — patches over furred block walls are built differently from patches in stud walls. Bigger or repeated damage belongs on the repair page.

Questions on drywall patching

Need help in Crystal River?

Call (352) 670-3571 or send the form. We will tell you plainly what the job needs and what it tends to cost before work starts.

Get a free estimate

Frequently Asked Questions

How is the price set?

Per visit, at $250 to $750 for a typical list. The visit — setup, coats, and dry time — drives the price more than the hole count does.

Can I just fill a hole with compound?

Only the very small ones — nail and screw marks. Anything wider needs backing or a fitted piece, or it will crack and telegraph through the paint.

How many visits does a patch take?

Most patches take two: one to set and coat, one to finish, sand, and texture — because coats need real dry time between them.

Can you match the texture around a patch?

In most cases yes. We test the match first and blend outward so no boundary line rings the patch.

Is the quote free?

Yes. Send photos with rough sizes; the list is priced as a group at no cost.

What Does My Drywall Project Cost?

Drywall is priced by the square foot of wall and ceiling surface — not by the size of your floor. That one fact explains most of the gap between quotes. Here are the ranges we see on real jobs around Crystal River, and a calculator built on the same numbers.

Drywall Repair & Patch

Most single repairs land between $250 and $800. Pros price patches by the square foot of damaged area — roughly $55–$75 a foot around Crystal River — but every repair carries a minimum job charge, because a patch takes the same setup and the same repeat trips for drying coats whether it's the size of a dinner plate or a door. Grouping several spots into one visit is the cheapest way to fix them: they share one minimum. Some repairs are priced flat by the job instead of the square foot: a cut-out ceiling section replaced and texture-matched (an 8×10 section ran $720 flat), long seam cracks (46 linear feet of re-taped seams across three rooms ran $540 flat), and popcorn removal finished smooth (230 sq ft ran $575 flat).

New Drywall Installation

For bare studs finished paint-ready (a standard Level 4 finish), plan on $1.60–$3.00 per sq ft of wall and ceiling surface, materials and labor included. A typical 12×12 bedroom with 8-foot ceilings — that's 528 sq ft of surface — runs about $890–$1,660 around Crystal River.

Room Remodel & Replacement

Tearing out old drywall and hauling it off adds $0.60–$1.25 per sq ft on top of new installation — a combined $2.20–$4.25 per sq ft. That same 12×12 bedroom, gutted and re-drywalled, runs about $1,210–$2,310. Opening walls can uncover surprises — water damage, old wiring — and those get priced once they're visible, never guessed at in advance.

Garage Drywall

Garages run $1.55–$3.30 per sq ft depending on finish. Code requires 5/8-inch fire-rated (Type X) board on the wall shared with the house, and on the ceiling when there's living space above it — that's the fire separation, not an upsell. Most two-car garages land between $1,900 and $4,100 finished.

Texture, Skim & Paint

On walls that are already up: skim coating runs $0.95–$1.30 per sq ft, orange-peel or knockdown texture $0.80–$1.85, and primer plus two coats of paint $1.05–$2.85. A typical room's walls — about 415 sq ft of surface — usually land between $750 and $1,980 for texture and paint together.

What Moves the Price

  • Finish level. A full Level 5 skim coat (for gloss paint or bright, raking light) costs more than standard paint-ready Level 4.
  • Ceilings. Overhead work runs roughly 20–25% more than the same area on a wall — lifts, heavier board, two sets of hands.
  • Ceiling height. Taller walls mean longer sheets, scaffolding, and slower work.
  • Texture matching. Blending a patch into existing orange peel or knockdown is hand work, and it's priced like it.
  • Tear-out. Removing old drywall and disposing of it is its own line on the quote.
  • Job size. Small jobs carry a minimum charge; on big jobs the setup spreads over more feet, so the per-foot price drops.

These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.

A note on materials. These ranges are figured with standard drywall board and the finish level you pick above. Board isn't all the same price, though: moisture- and mold-resistant board — the green or purple board for bathrooms and basements — costs more a sheet than standard board, and on a big job that can push you toward the top of your range, or a little past it. Tell us where the work is and we'll confirm the exact board and the price at the in-person estimate, before any work starts.

Estimate Your Project

1 · Pick your project
Your estimated range

Free — no obligation. Your calculator numbers ride along with the request.

📞 (352) 670-3571