Popcorn Ceiling Removal in Crystal River, FL
Popcorn ceiling removal in Crystal River costs $1.50 to $3.00 per square foot in 2026, scraped, skimmed, and finished smooth. A 200 square foot ceiling runs $300 to $600. Homes built before 1980 get a test first: some old texture holds asbestos, and no one should scrape that blind.
Talk to a Drywall Specialist: (352) 670-3571
Check your ZIP
Type your ZIP code. We will tell you if we serve your street.

A job like this one
A living room ceiling lost its popcorn and gained a smooth skim coat. The room was sealed in plastic first, so dust stayed in the work zone.
- Sample price
- $1.50 to $3.00 per sq ft
- Sample turnaround
- Two days with dry time.

The room gets sealed in plastic before the first scrape, with floors and vents covered. The texture comes off wet, which keeps dust down. Then a skim coat goes on, dries in full, and gets sanded and checked with a light before the ceiling is called done.
What the job covers
- The room sealed in plastic, with floors and vents covered
- Wet scrape of the old texture, down to the board
- A skim coat and sand, for a smooth, paint-ready ceiling
- Debris bagged and hauled off at the end
What it does not cover
- Work on a ceiling that tests hot for asbestos. That is a licensed abatement job, and we will point you to one.
- Paint, which is priced apart.
- Light or fan moves, which an electrician does.
Popcorn in Crystal River homes
Homes from the 1970s and 1980s across Citrus County still wear popcorn. It dates a room, holds dust, and stains fast when a roof drip hits it. Most rooms take two days with dry time and read ten years newer at the end. A ceiling that is stained or soft gets the water damage talk first, since scrape work on wet board is wasted work.
Questions on removal
Need help in Crystal River?
Call (352) 670-3571 or send the form. We will tell you plainly what the job needs and what it tends to cost before work starts.
Get a free estimate
Related Services
Drywall Finishing · Drywall Painting and Finishing · Taping and Mudding · Texture Matching
Frequently Asked Questions
How is the price set?
By the square foot: $1.50 to $3.00, scraped, skimmed, and finished smooth.
Is the test a must?
For homes built before 1980, yes. A test kit costs little and keeps the job safe. The fee, if you need one, shows at cost on the quote.
How long does a room take?
Two days with dry time for most rooms.
Can you just paint over popcorn?
You can, but paint locks in stains and makes a later scrape much harder. We show you both paths and their prices.
Is the site look free?
Yes. The look and the written quote cost nothing.
What Does My Drywall Project Cost?
Drywall is priced by the square foot of wall and ceiling surface — not by the size of your floor. That one fact explains most of the gap between quotes. Here are the ranges we see on real jobs around Crystal River, and a calculator built on the same numbers.
Drywall Repair & Patch
Most single repairs land between $250 and $800. Pros price patches by the square foot of damaged area — roughly $55–$75 a foot around Crystal River — but every repair carries a minimum job charge, because a patch takes the same setup and the same repeat trips for drying coats whether it's the size of a dinner plate or a door. Grouping several spots into one visit is the cheapest way to fix them: they share one minimum. Some repairs are priced flat by the job instead of the square foot: a cut-out ceiling section replaced and texture-matched (an 8×10 section ran $720 flat), long seam cracks (46 linear feet of re-taped seams across three rooms ran $540 flat), and popcorn removal finished smooth (230 sq ft ran $575 flat).
New Drywall Installation
For bare studs finished paint-ready (a standard Level 4 finish), plan on $1.60–$3.00 per sq ft of wall and ceiling surface, materials and labor included. A typical 12×12 bedroom with 8-foot ceilings — that's 528 sq ft of surface — runs about $890–$1,660 around Crystal River.
Room Remodel & Replacement
Tearing out old drywall and hauling it off adds $0.60–$1.25 per sq ft on top of new installation — a combined $2.20–$4.25 per sq ft. That same 12×12 bedroom, gutted and re-drywalled, runs about $1,210–$2,310. Opening walls can uncover surprises — water damage, old wiring — and those get priced once they're visible, never guessed at in advance.
Garage Drywall
Garages run $1.55–$3.30 per sq ft depending on finish. Code requires 5/8-inch fire-rated (Type X) board on the wall shared with the house, and on the ceiling when there's living space above it — that's the fire separation, not an upsell. Most two-car garages land between $1,900 and $4,100 finished.
Texture, Skim & Paint
On walls that are already up: skim coating runs $0.95–$1.30 per sq ft, orange-peel or knockdown texture $0.80–$1.85, and primer plus two coats of paint $1.05–$2.85. A typical room's walls — about 415 sq ft of surface — usually land between $750 and $1,980 for texture and paint together.
What Moves the Price
- Finish level. A full Level 5 skim coat (for gloss paint or bright, raking light) costs more than standard paint-ready Level 4.
- Ceilings. Overhead work runs roughly 20–25% more than the same area on a wall — lifts, heavier board, two sets of hands.
- Ceiling height. Taller walls mean longer sheets, scaffolding, and slower work.
- Texture matching. Blending a patch into existing orange peel or knockdown is hand work, and it's priced like it.
- Tear-out. Removing old drywall and disposing of it is its own line on the quote.
- Job size. Small jobs carry a minimum charge; on big jobs the setup spreads over more feet, so the per-foot price drops.
These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.
A note on materials. These ranges are figured with standard drywall board and the finish level you pick above. Board isn't all the same price, though: moisture- and mold-resistant board — the green or purple board for bathrooms and basements — costs more a sheet than standard board, and on a big job that can push you toward the top of your range, or a little past it. Tell us where the work is and we'll confirm the exact board and the price at the in-person estimate, before any work starts.
Estimate Your Project
Measure the damaged section itself — length × width. A full 4×8 sheet section is 32 sq ft.
Spots done in one visit share a single minimum charge.
Price includes tearing out the old drywall and hauling it off.
Includes 5/8″ Type X fire-rated board on the wall shared with the house — and on the ceiling when there is living space above it — as code requires.
Free — no obligation. Your calculator numbers ride along with the request.
Send Your Project to Crystal River Drywall Specialists
Your estimate is attached automatically. Add your info and — if you can — a few photos of the project. Photos help us price the job before we ever set foot in the house. Prefer to talk? Call (352) 670-3571.